MakerBot Digitizer Uživatelský manuál stáhnout pdf (Strana 45)

45SCANNING WITH YOUR MAKERBOT DIGITIZER

SCANNING AN OBJECT

Ensure that the camera ﬁlter is positioned

over the camera lens. Avoid touching the

camera ﬁlter or camera lens.

To begin a new scan, MakerWare for Digitizer must be in the New Scan state. You will

be taken to the New Scan screen at the end of the initial calibration and setup routine.

You can also access the New Scan screen at any time by choosing New Scan from the

Scanner menu.

TO SCAN AN OBJECT

See page 38 for guidelines on object

placement. Note that parts of an object

that extend outside of the scan cylinder will

be excluded from the scan and may aect

overall scan quality.

1 Position Filter on Camera Lens

2 Place Object on Platform

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 73 74

Žádné komentáře

MakerBot Digitizer Uživatelský manuál Strana 45