MakerBot Replicator Z18 Uživatelský manuál stáhnout pdf (Strana 21)

GETTING STARTED21

SETTING UP THE MAKERBOT REPLICATOR Z18

Locate and unwrap the Smart Extruder and

press it against the back of the extruder

carriage, with the connector pins facing the

front of the MakerBot Replicator Z18. Magnets

will lock the Smart Extruder into place.

1 INSTALL SMART EXTRUDER

Note: If you need to install the Smart Extruder

again at any time, go to the control panel and

select Utilities > System Tools > Attach

Smart Extruder.

Caution: Never remove the Smart Extruder from your MakerBot Replicator Z18 during or

immediately aer printing. Always allow the Smart Extruder to cool completely before removing it

from the MakerBot Replicator Z18.

2a. Locate the Large MakerBot PLA Filament

spool and remove it from its plastic bag.

2b. Push the right side of the ﬁlament drawer

to open it.

2c. Place the spool in the drawer with the

MakerBot logo facing up.

2 LOAD FILAMENT SPOOL

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 66 67

Žádné komentáře

MakerBot Replicator Z18 Uživatelský manuál Strana 21