MakerBot Replicator 2x Uživatelský manuál stáhnout pdf (Strana 12)

Page 11

Rev.2

G. Preheat (Optional)

Before you can begin printing, the build surface and the extruder nozzle need

to be preheated; this is an optional process, but will save up to 5 minutes of

your time.

To preheat, select: Preheat > Start Preheat!

Make sure both the Right Tool and the Platform are set to “ON”

Protip: The preheat process is a subroutine in the MakerBot software, this

means that when you start building a part, both the extruder nozzle(s) and the

platform will heat up instead of each individually, this saves time.

H. Load SD Card and Select your print

After all of the previous steps have been completed, you can print your part.

Load your SD card by placing in the slot and pressing until it clicks.

To start the print, select: Build from SD > (Your Part Name).x3g

Figure 7 - Preheating

Figure 8 - Print from SD

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

MakerBot Replicator 2x Uživatelský manuál Strana 12