MakerBot Replicator 2x Uživatelský manuál stáhnout pdf (Strana 13)

Page 12

Rev.2

I. What to do while printing

It is important to monitor your part while it is printing. If any of the following

problems occur, you can cancel your build by easily selecting: LEFT Arrow >

Cancel Print.

Problems that can occur are among the following:

Lifting – This is when the part lifts from the surface on one or more of its

edges. Lifted parts can be finished, but the surfaces won’t be uniform.

Separation – This is when the part lifts completely away from the build

surface, the part can then be dragged around by the hot extruder nozzle and

can make a mess if not caught. The print should be stopped if this happens!

PART IS LIFTING!

Figure 9 - Part Lifting

Part has separated!

Figure 10 - Part Separation

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

MakerBot Replicator 2x Uživatelský manuál Strana 13